The antibodies used in the kit were generated against and affinity purified from a cell lysate of CHO cells grown in serum supplemented media. All three of the TZY CHO HCP kits recognize a qualitatively vast majority of the same HCPs. The potential exists that the quantitative value reported for a given sample type may differ between the kits, therefore we cannot predict which kit will be most suitable for your applications. Formal qualification must be performed on each different product, to determine which of the 3 kits are superior. For labs looking at CHO HCP contamination for the first time, we suggest evaluating our CHO HCP ELISA, 3G, Catalog # F550. If this method proves inadequate then we suggest evaluating CHO HCP kits, Catalog #TK1798 and TK1797.
List Price: $689
  • Buy 5 for $654.55 each and save 5%
  • Buy 21 for $620.1 each and save 10%
  • Buy 31 for $585.65 each and save 15%
  • Buy 51 for

Properties

Protocol PDF Click for Protocol
Catalog Number TK01797
Species
Design Solid phase sandwich ELISA technique.
Standards 8 standards, serially diluted from 1 prepared lyophilized standard.
Controls None provided.
Sample Types CHO sample
Sample Volume 25 μL / determination.
Assay Desc. 2 hour incubation (RT) + 1 hour (RT) + 30 min. (RT) = 3 hours, 30 min. total incubation time.
Standard Range 0/2 - 200ng/mL
Sensitivity 0.4 ng/mL
Radioactivity
Other Names
Storage 2 - 8°C
Postscript For research use only, not for use in diagnostic procedures.

Intended use

This ELISA kit applies to the in vitro quantitative determination of CHO HCP concentrations in serum, plasma and other biological fluids.

Test principle

This ELISA kit uses the Sandwich-ELISA principle. The micro ELISA plate provided in this kit has been pre-coated with an antigen specific to CHO HCP. Standards or samples are added to the micro ELISA plate wells and combined with the specific antigen. Then a biotinylated detection antigen specific for CHO HCP and Avidin-Horseradish Peroxidase (HRP) conjugate are added successively to each micro plate well and incubated. Free components are washed away. The substrate solution is added to each well. Only those wells that contain CHO HCP, biotinylated detection antigen and Avidin-HRP conjugate will appear blue in color. The enzyme-substrate reaction is terminated by the addition of stop solution and the color turns yellow. The optical density (OD) is measured spectrophotometrically at a wavelength of 450 nm ± 2 nm. The OD value is proportional to the concentration of CHO HCP. You can calculate the concentration of CHO HCP in the samples by comparing the OD of the samples to the standard curve.

Typical data

As the OD values of the standard curve may vary according to the conditions of the actual assay performance (e.g. operator, pipetting technique, washing technique or temperature effects), the operator should establish a standard curve for each test. Typical standard curve and data is provided below for reference only.

Precision

Intra-assay Precision (Precision within an assay):
3 samples with low, middle,high concentration of CHO HCP. And the sample of CHO HCP were tested 30 times on one plate, respectively.
Inter-assay Precision (Precision between assays):
3 samples with low, middle,high concentration of CHO HCP. And the sample of CHO HCP were tested on 3 different plates, 30 replicates in each plate.

Recovery

Matrices listed below were spiked with certain level of CHO HCP and the recovery rates were calculated by comparing the measured value to the expected amount of CHO HCP in samples.

Matrix Recovery range (%) Average Recovery (%)
Serum (n=5) 92-100 96
EDTA plasma (n=5) 90-101 95
heparin plasma (n=5) 89-97 93

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of CHO HCP and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

    Serum (n=5) EDTA plasma (n=5) heparin plasma (n=5)
1:2 Range (%) 93-108 89-103 91-100
Average (%) 93 94 95
1:4 Range (%) 92-108 88-99 87-106
Average (%) 94 93 94
1:8 Range (%) 89-99 88-102 93-102
Average (%) 94 94 95
1:16 Range (%) 90-101 87-104 87-99
Average (%) 95 94 95

Stability

The stability of CHO HCP is determined by the loss rate of activity. The loss rate of CHO HCP is less than 5% within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Item Specifications Storage
Micro ELISA Plate(Dismountable) 8 wells ×12 strips -20℃, 6 months
Reference Standard 2 vials
Concentrated Biotinylated Detection Ab (100×) 1 vial, 120 μL
Concentrated HRP Conjugate (100×) 1 vial, 120 μL -20℃(shading light), 6 months
Reference Standard & Sample Diluent 1 vial, 20 mL 4℃, 6 months
Biotinylated Detection Ab Diluent 1 vial, 14 mL
HRP Conjugate Diluent 1 vial, 14 mL
Concentrated Wash Buffer (25×) 1 vial, 30 mL
Substrate Reagent 1 vial, 10 mL 4℃(shading light)
Stop Solution 1 vial, 10 mL 4℃
Plate Sealer 5 pieces
Product Description 1 copy
Certificate of Analysis 1 copy

Other supplies required

Microplate reader with 450 nm wavelength filter
High-precision transfer pipette, EP tubes and disposable pipette tips
Incubator capable of maintaining 37℃
Deionized or distilled water
Absorbent paper
Loading slot for Wash Buffer

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

© Copyright 2024 TZYBIOTECH. All Rights Reserved. SiteMap